Long landing rollout — LXJ356
KJAC · 192026-08-02 22:36 UTC· FLEXJET LLC· E55P
LXJ356 (Flexjet) was inbound to KJAC on 2026-08-02. SkyMeter detected a long landing rollout at Jackson Hole Airport (KJAC) on runway 19 at 22:36 UTC. Trace data at the event: 6400 ft AGL, 0 kt GS. METAR at the time reported 14 kt wind, 12 kt crosswind component, 16,093 m visibility. A long landing rollout is detected when ground deceleration after touchdown is below the per-runway P10 envelope. It is an observational measure of rollout efficiency, not a runway-exit incident. Detection algorithm and known limitations: see SkyMeter methodology.
Active FAA TFR during this flight
Source: FAA TFR archive (hourly snapshot)- HAZARDS6/6894 2026-07-20 14:02Z – 2026-08-03 04:00Z SFC–12,500 ft
12NM NW CRAIG, CO, Monday, July 20, 2026 through Monday, August 3, 2026 UTC
View FAA NOTAM →
SkyMeter cross-referenced this flight against FAA-published TFRs that were active during its window and within its geographic bounding box. Overlap doesn't necessarily mean violation — the aircraft may have been outside the TFR’s precise polygon or flying under air-traffic-control coordination.
Pilot review data
- Runway 19
- 6400 ft AGL at event
- 0 kt ground speed
- 0 fpm vertical
- 14 kt wind
- 12 kt crosswind component
- 16,093 m visibility
- KJAC 171056Z AUTO 02004KT 10SM BKN100 08/04 A3028 RMK AO2 SLP208 T00780044
Flight context
- LXJ356
- Flexjet
- E55P
- 2026-08-02 22:36 UTC
- KJAC runway 19
Automated analysis. Events shown on this page (such as go-around, unstable approach, or runway events) are heuristic classifications produced by algorithms from publicly broadcast ADS-B data. They are intended to surface flights of interest for further review — they are not findings of fact, and they do not determine pilot fault, regulatory compliance, or the cause of any occurrence. Coverage gaps and sensor noise can affect accuracy. Only the relevant civil aviation authority or accident investigation body can make official determinations. How we detect events · Dispute or correct this data